Tested Electrical Equipment Provides Safety To Your Home
There are many low voltage electrical devices which are regularly used at homes. Many have an idea that low-voltage contact is less hazardous than high-voltage contact, but it is not so. The truth is the other way.
Lightning can damage many things in your home like television sets and stereos or anything that plugs into an AC power source. By implementing a lightning arrestor into your homes electrical system you can greatly reduce the odds of experiencing damage due to the high voltage spikes that lightning can produce. These lightning arrestors can be purchased at any electrical supply.
These lightning arrestors can be installed easily in your main load center electrical panel. It would be better if you cut any excess wire and use only the length of wire needed to reach the required breaker and neutral/ground bar. The lightning hit will not be stopped by the lightning arrestor but definitely the blow will be moderate there by shielding the electrical equipments and apparatus.
Consult a qualified electrician if you have no experience in working with electricity. It is a good idea to verify that your homes grounding installations are properly bonded and meets local or national electrical code requirements to provide safety and avoid any hazards due to improper grounding procedures.
As your house might be full with the electrical appliances and fittings it is necessary that you have to maintain all the systems carefully so that you do not have to face any danger.
Electricity may seem to be harmless, but in the irony of it, lots of hazards are always present in electricity. These injuries range from shock to severe burns.
The advantages you can get from electricity is lightning, power, heating, communication etc, but if the electricity is not used as it is supposed to be then you may encounter many problems that may result to serious injuries to even death to living beings and devastation to many buildings and amenities.
If you are a handy do-it-yourselfer, you can easily replace an old, worn out or damaged electrical receptacle inexpensively and in a relatively short amount of time. First, and foremost, you cut the power to the outlet and then make double sure you flipped the right breaker. Use a voltage tester to make sure there is no live electricity before you get started. Use only rubber insulated tools.
About the Author:
Scott Rodgers' unbelievable knowledge and expertise on electrician works has been converted to some helpful write ups and tutorials on this occupation. With ample experience backing him, he has heavily consulted on lighting works from Walnut Electricians to Fort Lauderdale Electricians in the past.
---------------------------------------------------
You are receiving this because you signed up for it on 2009-07-21 from IP 72.22.138.32
To fine-tune your selection of which articles to receive, just login here
using your username: samdman
To unsubscribe please use the following link: unsubscribe
---------------------------------------------------
No comments:
Post a Comment